Panasonic aircon timer blinking
The Panasonic AC timer blinking
You might also experience a situation where your air conditioner turns off and even the air conditioner cannot turn off until the outside air conditioner is on continuously. If this happens, you should first check what the cause of your air conditioner is.
One such incongruity can occur because your AC timer is on and you may forget to activate it or you accidentally pressed the timer switch. The active timer feature is indicated by the timer lights in the room blinking. Then how do you turn it off? Following are the steps.
1. First, unplug the socket first.
2. Wait for about 2 to 5 minutes. After that, plug it back in.
3. The next step, remove the two batteries in the remote and replace them.
4. Now, turn on your air conditioner and air conditioner will run normally again.
The incongruity that occurs in Andac AC besides because you forget to turn off the timer feature can be caused by a number of things below.
1. Reduced freon pressure. This lack of freon can occur because the pipe connection is not perfect, it loosens due to engine vibration or it can also be due to a smooth leak in the installation pipe, condenser or evaporator.
2. Thermal damage / temperature sensor. Thermistor has a function as regulator of compressor work based on room temperature. If the mild temperature has reached maximum cold, it means that the thermic will turn off the compressor work and if the thermic is damaged, the timer lamp will blink. So in this case, you need to replace thermic.
3. Microprocessor damage. Microprocessor damage can occur due to electrical short circuit which often occurs or unstable electricity voltage fluctuations at a voltage of 220 volts. This can also cause the timer lamp or indicator light to flicker indicating AC damage.
4. AC compressor has a problem. A problematic compressor can occur on compressor electronic components such as overload, running capacitors or disconnected connecting cables.
If your Panasonic AC remote is damaged, you can use a universal AC remote. And how to set the timer you can follow the steps below.
1. Turn on the Panasonic AC first.
2. Press the button for about 5 seconds.
3.Press the temp button.
4. Then enter your Panasonic AC code.
5. Set a timer according to your wishes. If it doesn't work, do it repeatedly until you really manage it.
Even with remote, you can also find out AC damage. The trick is to press the button for 5 seconds. Wait and hold until there is a beep. Then write down the error code that appears. If so, press the button again for 5 seconds. And you can report this error code at an authorized Panasonic AC dealer.
So how to turn off the timer on the Panasonic AC and an additional explanation regarding AC. Now you don't need to be confused anymore and think of finding a way to turn off the AC Panasonic timer without remote because you can still try to do it with remote.
